Optimus 120-2117 Manual De Usuario

 
CAUTION:  Be careful to avoid obstructions behind the mounting surface. 
 
Routing Speaker Wire 
 
If you install speakers, avoid routing the speaker wires near moving parts  
or sharp edges.  You can usually route them along the wiring channel  
beneath the vehicle's door facing by carefully removing the molding that  
holds the carpet in place.  After you route the speaker wires, replace the  
molding. 
 
Testing the Stereo 
 
Before you mount the stereo or any speaker, test the stereo by temporarily  
connecting the power wire, speakers, and antenna as described in "Making  
the Connections," below.  If you plan to use an adapter harness to connect  
the stereo, see "Using an Adapter Harness," below. 
 
Making The Connections 
 
The supplied harness with the 14-pin connector includes all the lead wires  
you need to connect the stereo to ground, power, optional components, and  
speakers. 
 
IMPORTANT: Do not cut these wires.  If you cut any wire, you cannot obtain 
           a refund or exchange on this product. However, your local Radio 
           Shack store will provide warranty service if you cut a wire and 
           find the product is defective. 
 
Depending on your individual auto sound system, you might need additional 
wire to complete connections.  Your local RadioShack store carries a full 
line of wire and wire management accessories.  
 
CAUTIONS:  For added safety and to protect your stereo, remember to  
           disconnect the cable from your vehicle battery's negative (-)  
           terminal before you begin making the connections.  
 
           You must connect the ground and primary wires first, then make  
           all other connections before you plug the 14-wire harness into  
           the stereo.  (See "Using an Adapter Harness," below.) If you do 
           not make connections in the order shown, damage to the stereo 
           is possible if any wire connections are made incorrectly.  
 
           You must connect a separate wire to each speaker terminal as  
           described in the following procedure.  Do not use a common wire  
           or chassis ground for any speaker connection.