Philips DTR 7510 Manual De Usuario

Important

Your receiver is powered using an AC power cord. The Digital Terrestrial Receiver has been

manufactured to meet the appropriate safety standards, but the instructions below must be followed

to operate it safely. These instructions must be kept for future reference.

Danger

• The Digital Terrestrial Receiver does not contain any user-serviceable parts. Do not attempt to

open them. All maintenance work must be carried out by qualified services centres.

• The supplied mains plug may be a non-rewireable type or a rewireable type. Both types contain

an approved 3A fuse. If you need to replace the fuse, use an ASTA- or BSI-approved BS 1362 fuse,

rated at 3A and marked with either of these symbols.

• Non-rewireable plugs have the fuse beneath a fuse cover on the plug face. Use a screwdriver to

lever off the fuse cover, replace the fuse with a new one and refit its cover. Never use a plug if its

fuse cover is missing.

• Rewireable plugs have the fuse inside. Use a screwdriver to remove the plug’s back cover, then

lever out the fuse and replace it with a new one. Replace the plug’s back cover. If the supplied

mains plug is not suitable for your mains socket-outlet, remove its fuse and then cut the plug off

the lead. Destroy the severed plug immediately to avoid the shock hazard which would exist if this

were to be plugged into a mains socket. Do not attempt to repair or modify the mains lead or

plug. Fit an appropriate mains plug on the lead. If this plug contains a fuse, it should be as described

above. If you are using a non-fused plug, an external fuse must not exceed 5A.

• Make sure that children do not place any foreign objects in any of the openings.

Warnings

• Before connecting the AC power cord to the mains, check that the mains supply voltage

corresponds to the voltage printed on it. If the mains voltage is different, consult your dealer.

• The AC power cord has been designed for indoor use only.

• It is recommended to unplug the AC power cord from the mains during lightning storms.

• Periodically inspect the AC power cord for damage. Do not use if damage is found. Always refer to

qualified services centres.

• To prevent fire or shock hazard, do not expose the Digital Terrestrial Receiver to rain or moisture.

• The Digital Terrestrial Receiver should be placed on a firm surface, and the ventilation openings

must not be covered with items, such as newspapers, table clothes, curtains, etc.

• Do not install the Digital Terrestrial Receiver near heat sources such as radiators, stoves or other

apparatus that produce heat. Protect it from direct sunlight.

• When installing the Digital Terrestrial Receiver, ensure there is a gap of approximately 5 cm

around the Digital Terrestrial Receiver to enable air to circulate freely and prevent overheating.

• Leave accessible the AC power cord in case emergency shutdown is required.

• Do not place any combustible objects on the Digital Terrestrial Receiver (candles, etc.).

• No objects filled with liquids, such as vases, shall be placed on the unit. The Digital Terrestrial

Receiver shall not be exposed to dripping or splashing. Should this happen, disconnect the AC

power cord from the mains and consult qualified services centres.

• Do not move the product or turn the power off suddently while the hard disk drive is running.

The company shall not be liable for any corruption of data on the hard disk drive caused by the

carelessness or misuse of users.

Refer also to the cautions throughout this manual.

DTR 7510 200910.indd 5

16/10/2009 17:40:44