RBH Sound 1001RB/115 Manual De Usuario
11
1001RB Series
Rear Panel Controls
1- AC Receptacle:
The power cord is detachable and plugs in here.
2- 540W Amp Only:
540W power amp output for Full-Range operation only.
They deliver 540 watts into 4 Ohms. Lower impedances
should not be used. Each jack has a minimum of 8 Ohms
each. Higher impedances such as 8 Ohms, 16 Ohms, or
No Load are acceptable. No damage will result from
operating the amplifier with the speakers disconnected.
They deliver 540 watts into 4 Ohms. Lower impedances
should not be used. Each jack has a minimum of 8 Ohms
each. Higher impedances such as 8 Ohms, 16 Ohms, or
No Load are acceptable. No damage will result from
operating the amplifier with the speakers disconnected.
3- Speakon Outputs:
Enables BI-AMP operation by connecting a GK-RBH
Series cabinet with the provided 4 conductor Speakon
cable. This connects the 50W amplifier allowing the
Tweeter control on the front panel to control the signal
going to the horn. See Bi-Amp and Normal Operation
on page 7 for more information.
Series cabinet with the provided 4 conductor Speakon
cable. This connects the 50W amplifier allowing the
Tweeter control on the front panel to control the signal
going to the horn. See Bi-Amp and Normal Operation
on page 7 for more information.
Caution:
Do not connect a Speakon cable labeled “Bridge
Mode” to the 1001RB. This may result in damage to the
amplifier.
Mode” to the 1001RB. This may result in damage to the
amplifier.
Maximum Recommended Load:
One 4 Ohm or two 8 Ohm cabinets on the 540W Amp.
One or two 8 Ohm horns on the 50W Amp.
One or two 8 Ohm horns on the 50W Amp.
CAUTION:
UNDER NO CIRCUMSTANCES
SHOULD THE 540W AMP AND THE
50W AMP BE CONNECTED
TOGETHER OR BE CONNECTED
TO THE SAME SPEAKER !!!
11
Rear
Panel
Controls
3
2
1