Blaupunkt CDC-RF6IR Manual De Usuario

l 

Carefully choose the mounting location so that the unit won’t interfere with normal driving.

l 

Avoid installing the unit it a place:

 Subject to temperatures exceeding 55 degrees C (131 degrees   (such as in a car parked in direct

sunlight.)

 Subject to direct sunlight
 Subject to excessive vibration

 Near heat sources (such as heaters and heat ducts)

 Exposed to rain, moisture, excessive dirt and/or dust

l 

This unit should not be installed in any way except that which is authorized (on its side, on its end, at
a 45” angle or suspended). Installing it with its side facing down or upside down can cause
malfunctioning.

l 

The fuel tank must not be damaged by the installation.

l 

The unit should not cover any wires or pipelines.

l 

The unit (and its installation) should not damage or interfere with access to the spare tire, tools or
other equipment in or under the trunk.

l 

For a safe and secure installation, be sure to use only the supplied mounting hardware.

l 

Press the reset button after completing the electrical connections and installation. The reset button is
located on the front of the chassis (See page 5).

l 

If you have any questions or problems concerning your unit that are not covered in this manual,
please contact your Blaupunkt dealer.

l 

Be sure to remove the transport screws (See page 5).

l 

This unit can be installed horizontally (to the floor or suspended), vertically, and at a 45” angle.

l 

Once the installation position has been chosen, set Anti-Vibration Setting Switches on both sides of
the unit using a screwdriver.

l 

The unit may skip if used with the wrong installation setting.

Horizontal

Suspended
Vertical
45” angle

H
H
V

45”

Bracket (L)

(4)

Tapping Screw

 12)

Bracket (R)

Bracket (B)

(4)

Hexagonal Bolt

 x20)

(4)

Hexagonal Bolt

With Washer

(4)

Nut

(M6)

Tapping Screw

DIN 8 Pin Cable

Seal

Double

Sided Tape