Sony ACY-RKSL Manual De Usuario

Removing the Library from the Rack

15

Press the locking arm to release the lock, and then 
slide the library all of the way into the rack.

Hand tighten the screw on one of the L-shaped 
brackets on the front of the rack so that the library 
is secured in place.

Hand tighten the screw on the other L-shaped 
bracket the same manner.

Confirm that the library is housed properly in the 
rack.
Once the library is mounted in the rack, connect the 
power cord and the SCSI cables and make all 
necessary settings as described in the Quick Start 
Guide and Operating Instructions (PDF).

With a single drive installed, the S-AIT library weighs 
approximately 27 kg/59.5 lbs. (With two drives 
installed, the S-AIT library weighs approximately 
31 kg/68.3 lbs.)
At least two people are needed in order to handle the 
library. Handling the S-AIT library on your own could 
result in back injury or other accidents resulting in injury 
or damage to the S-AIT library.

Turn off the library.
To turn the power off, press the rear power switch.

Disconnect all of the cables.

Loosen the screws in both of the L-shaped brackets.

Pull the library out of the rack.

If necessary, remove the rail assemblies and 
brackets from the rack.

If necessary, remove the inner rails and L-shaped 
brackets from the library.

Locking arm

Fastener