Solo USA 450 Manual De Usuario

Starting / Stopping the engine 

ENGLISH

  12 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

•  Switch ignition switch to ”I” position and close  (OFF) 

formula on/off tap . 

•  Move  throttle lock lever to ”Start” position.  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
  

•  Close choke with choke lever. 

 

•  Press primer several times until fuel is visible in the 

primer. 

•  Place your left hand on the formula tank of the 

mistblower. Hold the starter handle (Fig. 1.Pos. 7) 
with your right hand  and pull the handle up slowly 
until resistance is felt. Then pull up firmly and rapidly 
until the engine ‘fires’. 

•  Once the engine tries to start, immediately open the 

choke 

 and continue to start. 

•  When the engine runs, use the throttle lever to 

accelerate to the required engine speed. For 
continuous use, set the throttle lock lever (Fig. 1, 
Pos. 18) in the required position for the desired 
engine speed. 

•  To return to idling speed, either release the throttle 

lever or move throttle lock lever down to ”min” 
position. 

 
Starting with warm engine after short stop 

•  Leave choke in ”open” position 

 and start engine. 

 
Should the engine refuse to start despite several 
starting attempts, the combustion chamber is most 
likely flooded. 
In this case we recommend you remove and dry the 
spark plug (Fig.1, 4). Set the ignition switch to ”stop” 
and set throttle lock lever (Fig. 1, 18) to full throttle 
position ”max”. Pull over engine several times, still with 
spark plug removed. This will ventilate the combustion 
chamber 
Replace spark plug and repeat starting procedure. 
 

•  Release throttle lever and move throttle lock lever to 

”min” position. 

•  Move ignition switch to ”Stop” position until engine 

stops.