Cub Cadet CS 2210 Manual De Usuario

Branches up to two inches (model series CS 2210) or three inches 

(model series CS 3210) in diameter may be fed into the chipper 

chute for chipping.

Leaves, twigs, and branches up to 1/2-inch in diameter may be 

placed into the hopper for shredding. See Fig. 4-1.
IMPORTANT: Never place branches with a diameter greater than 

1/2-inch in the hopper. Doing so can result in serious damage to 

your unit’s shredder blade, flails or impeller.

Use the tow bar to tow the chipper shredder behind a tractor to 

a job site.

Use the handle when manually transporting the chipper 

shredder.

The recoil starter is located on the engine. Pull the recoil starter 

to start engine.

See the engine Owner/Operator manual packed with your unit 

for the location and function of the controls on the engine.

The spring latch is located on the top of the hopper. It is used to 

release or lock the chipper chute in a raised position for storage 

or for transporting. See Fig. 4-1.

Never operate the chipper shredder 

with the chipper chute in the raised position. Use 

the spring latch to lower the chipper chute into the 

operating position before starting the engine.

The lock rod is located on the chipper chute support. It is used 

to release or lock the chipper chute in a lowered position for 

operation.