Craftsman 486.240362 Manual De Usuario

4

TOOLS REQUIRED FOR ASSEMBLY
(1) Phillips Screwdriver 
(1) Adjustable Wrench 
(1) 7/16" Open End or Box Wrench 

 

1.  Assemble the two Handle Leg Stand Tubes to the 

Sweeper Housing, using two hex bolts 1/4-20 x 1-
1/4" long, fl at washers and 1/4-20 hex lock nuts, per 
handle. See fi gure 1. Only hand tighten at this time.

2.  Assemble the Upper Handle Tube over the Handle 

Leg Stand Tubes. See fi gure 2. Align holes in handle 
and assemble the Bag Rod Clips to the handle as 
shown and fasten with curved head bolts and hex lock 
nuts.

3.  Now tighten the four bolts from step 1.

4.  Assemble a bag rod clip to the inside of each lower 

handle tube using a curved head bolt secured down 
against the clip using a 1/4" lock nut. The open end 
of the clips should face towards the sweeper housing. 
See fi gure 3.

5.  Slide the long bag rod (28-1/2" long) through the 

stiched bag fl ap on the top of the hopper bag as 
shown in fi gure 4.

6.  Slide the short bag rod (25-1/2" long) through the 

stiched bag fl ap on the bottom of the hopper bag as 
shown in fi gure 4.