Craftsman 486.24029 Manual De Usuario
ASSeMBLY
TOOLS reQUired FOr ASSeMBLY
(2)
7/16" Wrenches
(2)
1/2" Wrench
(1) Pliers
(1) Hammer
(1) Hammer
STep 1:
(See FigUre 1)
•
Install a 1/4-20 x 1" hex bolt (39) and a 1/4" hex nut
(25) in each bag arm channel and then place a 1/4"
washer (43) onto the end of the bolt.
(25) in each bag arm channel and then place a 1/4"
washer (43) onto the end of the bolt.
STep 2:
(See FigUre 2)
•
Slide the bag arm channels (4) into the sweeper
housing as shown in figure 2. Secure them to the
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). Tighten bolt until snug.
housing as shown in figure 2. Secure them to the
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). Tighten bolt until snug.
do
not overtighten.
STep 3:
(See FigUre 3)
•
Secure each bag arm channel to the side of the
sweeper housing with a wing nut (31) and a washer
(43) installed on the bolt assembled in step 1.
sweeper housing with a wing nut (31) and a washer
(43) installed on the bolt assembled in step 1.
•
Insert a pivot rod retainer (30) down into the end of
each bag arm channel.
each bag arm channel.
•
Install a compression spring (32) into the bottom of
each of the pivot rod retainers to secure them to the
bag arm channels.
each of the pivot rod retainers to secure them to the
bag arm channels.
FigUre 4
STep 4:
(See FigUre 4)
•
Attach the drawbar (14) to the sweeper by fastening
a drawbar bracket (8) above and below the drawbar
using two washers (68), three 5/16" x 2-1/2" hex bolts
(15) and 5/16" nylock nuts (21).
a drawbar bracket (8) above and below the drawbar
using two washers (68), three 5/16" x 2-1/2" hex bolts
(15) and 5/16" nylock nuts (21).
FigUre 1
FigUre 2
15
4
21
FigUre 3
8
15
14
21
8
68
68
31
30
32
43
39
4
25
43
5