Dimension One Spas Bay Collection Manual De Usuario

Descargar
Página de 72
2004 Bay Collection 
Owner’s Manual 
 
Safety First 
Your safety, and the safety of your family and friends, is very important! It is vital to everyone’s 
safety that you read and heed the following safety precautions. Review them as often as necessary to ensure 
that your enjoyment of your new Dimension One Spas, Inc. product is always safe. 
IMPORTANT SAFETY INSTRUCTIONS 
READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY 
When installing and using this equipment, basic safety precautions should always be followed, including: 
•  Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access 
by children. To avoid accidents, ensure that children cannot use this spa unless they are supervised at 
all times. 
• 
Risk of Serious Injury or Death. The suction fittings in this spa are sized to match the specific 
water flow created by the pump. Should the need arise to replace the suction fittings or the pump, be 
sure that the flow rates are compatible. Never operate the spa if the suction fittings are broken or 
missing. Never replace a suction fitting with one rated less than the flow rate marked on the original 
suction fitting.
 
• 
Risk of Electric Shock. Install at least 5 FEET (1.5 m), from all metal surfaces. As an alternative, a 
spa may be installed within 5 feet of metal surfaces if each metal surface is permanently connected by 
a minimum No. 8 AWG (8.4 mm2) solid copper conductor attached to the wire connector on the 
grounding lug, inside the equipment compartment on the equipment can.
 
• 
Risk of Electric Shock. Do not permit any electrical appliance, such as a light, telephone, radio, 
television, etc. within 5 feet (1.5 m) of a spa.
 
• 
The electrical supply for this spa must include a suitably rated switch or circuit breaker to open all 
ungrounded supply conductors to comply with section 680-42 of the National Electrical Code, 
ANSI/NFPA 70-1993. The disconnect must be readily accessible and visible to the spa occupant but 
installed at least 5 feet (1.5 m), from the spa water.
 
• 
A grounding wire connector is provided on this spa to connect a minimum No. 8 AWG (8.4 mm2) 
solid copper conductor between this unit and any metal equipment, metal enclosures of electrical 
equipment, metal water pipe, or conduit within 5 feet (1.5 m) of the spa.
 
• 
To Reduce the Risk of Injury: The water in a spa should never exceed 104° F (40° C). Water 
temperatures between 100° F (38° C) and 104° F (40° C) are considered safe for a healthy adult. 
Lower water temperatures are recommended for young children and when spa use exceeds 10 
minutes.
 
• 
To Reduce the Risk of Injury: Since excessive water temperatures have a high potential for 
causing fetal damage during the early months of pregnancy, pregnant or possibly pregnant women 
should limit spa water temperatures to 100° F (38° C).
 
• 
To Reduce the Risk of Injury: Before entering a spa, the user should measure the water 
temperature with an accurate thermometer since the tolerance of water temperature-regulating 
devices may vary as much as +/- 5° F (2° C).
 
• 
To Reduce the Risk of Injury: The use of alcohol, drugs, or medication before or during spa use 
may lead to unconsciousness with the possibility of drowning.
 
• 
To Reduce the Risk of Injury: Persons suffering from obesity or with a medical history of heart 
disease, low or high blood pressure, circulatory system problems, or diabetes should consult a 
physician before using a spa.
 
•  To Reduce the Risk of Injury: Persons using medication should consult a physician before using a 
spa since some medication may induce drowsiness, while other medication may affect heart rate, 
blood pressure, and circulation.  
•  Do not attempt to remove the light housing cover without lowering the water level below the light 
housing cover. 
1