Jacuzzi HE97000 Manual De Usuario
Comfort Whirlpool Bath
Installation and Operation
www.jacuzzi.com
Page 7
English
Introduction
The drain/overflow of the bath extends below the bottom of
the bath. Note that this requires a cutout in the floor.
The floor structure beneath the bath must be able to
The floor structure beneath the bath must be able to
support a total weight of bath, water, and bather. Refer
to the table under total weight for your model.
The unit must be supported from the bottom of the bath and
The unit must be supported from the bottom of the bath and
not from the bath rim or tile flange. If the subfloor is level
and a continuous surface, no other preparation is necessary.
You can proceed to install the bath.
If the subfloor is not
level, you
MUST level the entire surface prior to installing
the bath. The use of materials that shim or provide a level
installation are allowed provided the method used will insure
a level bath that is supported from the bottom. Materials that
may be used are a floor leveling compound, mortar, plaster
or minimal expansion structural foam having a density of a
minimum of 5 lbs./cubic ft.; however, the bath must remain
level in order for it to drain properly and all foam feet must
make full contact with the leveling material. Both sides of
a joint or splice of subfloor should be level to each other.
When attaching baths with flanges to stud wall, use shims to
fill any gaps between the bath flange and studs.
The rim of the bath is not designed to support weight. If
The rim of the bath is not designed to support weight. If
finish material is to overlap or contact the bath, the added
weight must be fully self-supporting.
If a skirt is to be used, it must be installed at
the time of unit installation – refer to skirt
installation instructions. Install optional trim parts
when all installation has been completed.
FLUSH TO THE WALL
SEMI-SUNKEN
OPTIONAL TILE FLANGE KIT
On the Riva™ 5 and Riva™ 6, the discharge plumbing
extends slightly beyond the bath rim. When installing
either bathtub as semi-sunken, lower the pump/motor
side in first into the cut out.
Tile
Sealant
Mortar/
Adhesive
Adhesive
Flashing
1˝ x 4˝ (not for
support)
Mortar/
Adhesive
Tile
Tile
Sealant
Flashing
1˝ x 4˝ (not for
support)
1˝ x 4˝ (not for
support)
Stud Wall
Mortar
Cement Board
Cement Board
Bath Rim
Plastic Filler
Finishing Material
Flange
Screw
Subfloor
Silicone Selant
Figure 1