Graco 24F214 Manual De Usuario
7.
Connect chemical injector hose (5) to valve (1) at
barbed fitting.
barbed fitting.
8.
Install the suction hose (3) at the pump inlet.
9.
Screw strainer (2) onto the end of the suction hose.
Table 1: Wrench Sizes
Table 2: Torque Specifications
Operating Instructions
1.
Place the suction hose and chemical injector hose
into the water supply.
into the water supply.
2.
Start engine (see engine manual provided with
pressure washer for correct engine starting proce-
dure).
pressure washer for correct engine starting proce-
dure).
3.
With nozzle removed, squeeze gun trigger so water
begins to flow from hose/gun assembly (this allows
the unit to prime and purge any air from the system).
The unit is primed once water flow is uninterrupted
by air.
begins to flow from hose/gun assembly (this allows
the unit to prime and purge any air from the system).
The unit is primed once water flow is uninterrupted
by air.
4.
Once unit is primed, release trigger and lock gun in
OFF position. Securely connect desired nozzle
assembly.
OFF position. Securely connect desired nozzle
assembly.
NOTE: Refer to instruction manual supplied with the
unit for any further operating instructions.
unit for any further operating instructions.
ti17848a
ti17849a
ti17850a
Model Number
Wrench Size
2730 DD
22mm
3030 DD and 3540 DD
27mm
4043 BD
30mm
Model Number
Torque
2730 DD
60 ft-lb (81 N•m)
3030 DD and 3540 DD
73 ft-lb (99 N•m)
4043 BD
73 ft-lb (99 N•m)