Chicago Electric 39461 Manual De Usuario

Descargar
Página de 23
 
GENERAL MAINTENANCE 
 
ENGINE FUEL:  Use Unleaded Fuel - ONLY! 
 
ENGINE OIL:  Refer to the Engine related 
documentation. 
 
ENGINE MAINTENANCE: 
Refer to the documentation supplied regarding the 
engine for all engine maintenance issues. 
 
 
GENERATOR CLEANING 
 
CAUTION!:  ALWAYS SHUT OFF THE 
GENERATOR AND ALLOW THE GENERATOR 
TO COMPLETELY COOL BEFORE 
PERFORMING CLEANING OPERATIONS. 
 
WARNING!  DO NOT USE HIGH PRESSURE 
WATER OR A GARDEN HOSE TO CLEAN 
YOUR GENERATOR. WATER INTRODUCED 
INTO THE GENERATOR CAN CAUSE ELECTRICAL 
SHORTS, GENERATOR DAMAGE OR PERSONAL 
INJURY. 
 
 Compressed air (max. 25 psi) may be used to blow 
loose dirt and dust from your generator.  DO NOT 
DIRECT COMPRESSED AIR DIRECTLY INTO ANY 
OPENING IN THE GENERATOR OR ENGINE. 
 Use a dampened cloth to wipe clean exterior 
surfaces. 
 Use a soft bristle brush to clean/ loosen heavy dirt, oil 
or grease deposits. 
 NEVER insert rags, tools or any device into the 
generator or engine openings. 
 
GENERAL STORAGE GUIDELINES 
 
WARNING:  GASOLINE FUMES ARE 
FLAMMABLE. 
DO NOT STORE YOUR 
GENSET IN ANY AREA THAT IS INDOORS OR 
IN POORLY VENTILATED AREAS. GASOLINE FUMES 
CAN IGNITE IN THE PRESENCE OF ANY OPEN 
FLAME, PILOT LIGHT, CLOTHES DRYER, WATER 
HEATER, ETC. 
 
 Your generator should be started and operated for 
several minutes at least every 30 days. 
 If the generator cannot be operated every 30 days, 
follow the storage recommendations within the engine 
documentation. 
 NOTE:  A fuel shut-off valve is positioned at the base 
of the fuel tank.  The valve should be closed during 
storage periods. 
 
 
 
 
GENERAL BATTERY INSTALLATION 
 
WARNING:  DO NOT ATTEMPT TO OPERATE 
THE GENERATOR WITHOUT THE BATTERY 
INSTALLED UNLESS BOTH THE RED(+) AND 
BLACK(-) CABLE ENDS ARE COMPLETELY 
INSULATED OR THE CABLES ARE REMOVED 
ENTIRELY. 
 
BATTERY SPECIFICATION: 145 CCA; INTERSTATE 
BATTERY
 Model SP-18 or Equivalent 
 
With reference to the diagram below and to the safety 
guidelines that must be respected for handling batteries, 
install the battery as follows: 
 
 
1.  Place the battery into the battery tray. 
2.  Place the battery hold down bar (oriented as shown) 
on top of the battery. 
3.  Install qty (2) battery hold down bolts and washers as 
shown. 
NOTE:  Some versions require lock washers and nuts 
on lower side of battery tray. 
4.  Gently and evenly tighten the battery hold down bolts. 
Do not crush and or deform the battery case in the 
tightening process. 
5.  Insure that the engine key switch is in the 
“off” 
position. 
6.  Connect the red (+) cable to the battery (+) terminal 
using the supplied bolt, washers and nut. Tighten the 
bolt. 
7.  Connect the black (-) cable to the battery (-) terminal 
using the supplied bolt, washers and nut. Tighten the 
bolt. 
 
 
 
 
Battery Installation Diagram