Edirol R-4Pro Manual De Usuario
86
Appendix
Setting the internal timecode start time
fig.recording-1.eps
1
Press the [SYSTEM] button on the R-4 Pro.
The display shows the System Menu screen.
fig.time-code-1.eps
2
Use the
[CURSOR] button
to select
6 Timecode
, and press
the
[ENTER] button.
The Timecode screen is shown.
fig.time-code-2.eps
3
Use the [CURSOR] button to select
2 Set Int TC
, and
press the [ENTER] button.
The display shows the Set Int TC screen.
fig.time-code-set-int.eps
4
Use the [CURSOR] button to select the input location,
and then set the start time with the [SCRUB/VALUE]
dial.
and then set the start time with the [SCRUB/VALUE]
dial.
* H:M:S:F: indicates Hours: Minutes: Seconds: Frames, respectively.
The F value differs according to the Frame Rate value in the Timecode
Setup.
Setup.
* To cancel the settings, press the [EXIT] button.
fig.time-code-4.eps
5
Press the [ENTER] button.
After the screen shown in the figure to the right is displayed, the
set time is shown as CURRENT, and the timecode begins.
set time is shown as CURRENT, and the timecode begins.
6
After setting the value, press the [EXIT] button.
The display returns to the Timecode screen.
7
Return to the Main screen by pressing the [EXIT] button again.
Setting the start time
R-4_e_new.book 86 ページ 2006年11月20日 月曜日 午後1時9分