Graco 3A1902C Manual De Usuario

Contents

Install Air Compressor

Reference parts illustration, Parts, page 7 .
1. Remove the battery bracket and fuel tank. See

system repair manual for instructions.

2. Turn the B side y-strainer inlet on the Reactor

as shown.

NOTICE

Be careful to not damage engine components.

3. Loosely assemble the front bracket (2) to pallet

using two screws (10).

4. Install the side support gusset (5) to the pallet

with four screws (10) and nuts (11) as shown. Do

not tighten the screws.

5. Install the rear bracket (1) on the pallet with ﬁve

screws (9) and nuts (11). Do not tighten the

screws.

6. Install the six screws (10) and nuts (11) through

the top of the support gusset (5). Do not tighten

the screws.

7. Assemble the top plate assembly (3) to frame

with 14 screws (9) and nuts (11). Do not tighten

the screws.

8. Lift side of gusset (5) to ensure top plate (3) is

level before tightening. Tighten all screws and

nuts.

9. Install four isolators (8) with screws (10) on top

plate assembly (3).

Use lifting device to prevent personal injury

when lifting the compressor. Do not overlap

lifting straps over tubing or other fragile

components.

10. Lift the air compressor (7) onto the isolators (8).

Secure the air compressor to the isolators with

four screws (28), washers (29).

11. Install elbow adapter (13) in air compressor

outlet.

12. Remove plug and install elbow ﬁtting (41) on

compressor pilot valve (see parts illustration).

13. Remove compression nut cap and install

compression nut ﬁtting (37). Tighten ﬁnger tight

only.

14. Install end caps (32).

3A1902C