Crestron electronic TPS-15G-QM Manual De Usuario

 Isys

®

 G-Series Touchpanels 

 Crestron TPS-12G/15G/17G-QM

Color Control 
(Continued) 

 

Blue

1, 2

 

Adjusts the amount of blue in the video signal. Available 
when the RGB Color button is selected. 

Overscan

3

 

These controls adjust the amount of video information at the 
edges of the image. This part of the video picture is usually 
beyond the display capabilities of the screen. 

None

3

 

Sets the video screen so there is no overscan. The amount 
of used screen area is smallest in this configuration. 

Normal

3

 

Sets the video screen for normal overscan. This results in 
more area of the screen being used. 

Max

3

 

This sets the video screen area to the maximum. The 
screen area is largest in this configuration. All video 
information at the edges is visible. 

Size and Position 

When RGB is selected as the video source, these controls 

are available when the RGB Size and Position button has 
been pressed. 

Calibration 

Calibrates the incoming RGB signal for optimal position, 

size and phase when Perform Calibration button is 
pressed. In Auto Mode, the panel will attempt to find a 
matching preset based on the RGB signal’s characteristics. 
If it cannot find one, it automatically performs a calibration. 
In Manual Mode, the panel will not attempt to find a 
matching preset nor will it automatically perform a 
calibration. In either mode, you can always adjust the 
settings (Position, Size, Phase Coarse, Phase Fine) 
manually. Settings are not saved to a preset unless the user 
presses the Store Preset button. 

Position 

This control allows you to set the position of the video 

screen on the touchpanel. The arrow buttons move the 
screen along the X and Y axis. 

Restore 

Default 
Position 

Returns the video screen to its original position on the 

touchpanel. 

Size 

Allows you to set the size of the video screen in both the 

vertical and horizontal directions. 

Restore 

Default Size 

Returns the video screen to it original size on the 

touchpanel. 

Phase 

These controls adjust the phase of the RGB signal. Controls 

are shown for both coarse and fine adjustments. 

Restore 

Default Phase 

Returns the video signal to its original default phase. 

1. 

Video default is zero (0) for each of the video parameters (brightness, contrast, red, green and blue). 

2. 

Adjustment applies to the currently selected video source only. 

3. 

These controls are available only in Video, S-Video and Component  modes. In RGB mode they are 
analogous to the Position, V Size and H Size controls. 

 

•  Isys