Cisco Systems OL-7822-06 Manual De Usuario
4-2
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Perform the Initial System Configuration
The above SCE 1000 port parameters are fixed and are not configurable.
Step 1
Plug the <SKIP>serial cable provided with the SCE 1000 into the CON port on the front panel of the
SCE 1000.
SCE 1000.
Step 1
Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible
local (serial) terminal.
local (serial) terminal.
Step 2
At the console. press
Step 3
Enter
Step 4
several times until the Cisco logo appears on the local terminal and the setup configuration dialog is
entered.
entered.
--- System Configuration Dialog ---
At any point you may enter a question mark ‘?’ followed by ‘Enter’ for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets ‘[]’.
Would you like to continue with the System Configuration Dialog? [yes/no]: y
Step 5
Type y and press press Enter.
Enters the system configuration dialog.
Perform the Initial System Configuration
•
•
•
•
•
•
•
•
•
•
•
Initial System Configuration
•
•
•