Cisco Systems AIRCAP1552HAK9 Manual De Usuario

The access point can be installed where power is available, without the need for a wired LAN connection. 
The access point uses intelligent wireless routing that is based on the Adaptive Wireless Path Protocol 
(AWPP). AWPP enables a remote access point to dynamically optimize the best route to the wired LAN 
network using another access point. 

The 1552 access point uses the 5-GHz radio for the Mesh backhaul and connections. The 2.4-GHz radio 
is used for local wireless client access. 

To mount your access point on a vertical pole or streetlight pole, you need to install two metal bands 
around the pole to support the access point. This process requires extra tools and material not provided 
in the pole mount kit (see 

To mount the access point onto a vertical pole or streetlight pole, follow these steps:

Select a mounting location on the pole to mount the access point. You can attach the access point to any 
pole from 2 to 16 inch (5.1 to 40.6 cm) in diameter.

If you will be using a streetlight power tap adapter, position the access point within 3 ft (1 m) of 
the outdoor light control.

For poles larger than 3.5 inch (8.9 cm), mount the pole clamp bracket assembly to a pole (see 

) using two metal straps. Following the instructions provided with the banding strap tool 

(BAND IT) (AIR-BAND-INST-TL=), loop each metal strap twice through the slots on the strap bracket.

Do not place the metal straps in the large open area between the pole clamp bracket and the strap 
brackets, because this does not properly secure the access point.

Vertical or streetlight pole

Two 0.75-in (1.9 cm) stainless steel bands

Banding strap tool (BAND IT) (Cisco 
AIR-BAND-INST-TL=)

Ground lug (provided with access point)

Crimping tool for ground lug, Panduit CT-720 with 
CD-720-1 die (http://onlinecatalog.panduit.com) 

#6 AWG ground wire

Yes

No

Yes

No

No