Cisco Systems 1550 Manual De Usuario
4-5
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 4 Installing or Replacing the Backup Battery
Installing a New Backup Battery
Step 3
Use a Phillips screw driver to remove the four screws attaching the backup battery to the cover
(see
(see
Figure 4-3
Backup Battery Screws
Installing a New Backup Battery
Note
The AIR-1520-BATT-6AH= backup battery is used only on access point models AIR-CAP1552E-x-K9
and AIR-CAP1552EU-x-K9. Do not use this battery on model AIR-CAP1552H-x-K9,
AIR-CAP1552SA-x-K9, or AIR-CAP1552SD-x-K9.
and AIR-CAP1552EU-x-K9. Do not use this battery on model AIR-CAP1552H-x-K9,
AIR-CAP1552SA-x-K9, or AIR-CAP1552SD-x-K9.
To install a new backup battery into your access point, follow these steps:
Step 1
Carefully orient your new backup battery as shown in
over the access point radio cover.
Step 2
Position the backup battery over the four screw holes in the radio cover.
Step 3
Use the four supplied screws to attach the backup battery to the radio cover and tighten to 5.5 to 6.5 in.
lbs (0.62 to 0.73 Nm).
lbs (0.62 to 0.73 Nm).
Step 4
Position and bend the backup battery cable as shown in
1
Battery backup screws (4 places)
3
Backup battery
2
Battery backup cable and connector
4
Access point radio cover