Cisco Systems 1550 Manual De Usuario

To configure DHCP Option 43 for Cisco 1000, 1500, and 1550 series access points in the embedded 
Cisco IOS DHCP server, follow these steps: 

Enter configuration mode at the Cisco IOS command line interface (CLI). 

Create the DHCP pool, including the necessary parameters such as default router and name server. These 
commands are used to create a DHCP pool: 

 pool name 

 IP Network Netmask 

 Default router 

 DNS Server

Where:

pool name is the name of the DHCP pool, such as AP1000

IP Network is the network IP address where the controller resides, such as 10.0.15.1

Netmask is the subnet mask, such as 255.255.255.0

Default router is the IP address of the default router, such as 10.0.0.1

DNS Server is the IP address of the DNS server, such as 10.0.10.2

Add the Option 60 line for access point using the following syntax: 

VCI string” 

For the VCI string, use the value from 

. The quotation marks must be included. 

Add the Option 43 line using the following syntax: 

Comma Separated IP Address List” 

For example, if you are configuring Option 43 for Cisco 1000, 1500, or 1500 series access points using 
the controller IP addresses 10.126.126.2 and 10.127.127.2, add the following line to the DHCP pool in 
the Cisco IOS CLI: 

 

The quotation marks must be included.