Cisco Systems 1550 Manual De Usuario

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 
Statement 1030

Installation of the equipment must comply with local and national electrical codes. Statement 1074

To provide inline PoE, you must use the power injector (AIR- PWRINJ1500-2=) specified for the access 
point. Other power injectors, PoE switches, and 802.3af power sources do not provide adequate power, 
which might cause the access point to malfunction and cause over-current conditions at the power 
source. You must ensure that the switch port connected to the access point has PoE turned off.

Refer to these sections for installation details:

When mounting an access point on a horizontal or vertical surface, you must ensure that the access point 
is oriented with the LED indicators pointing down (see 

, and 

). This 

positioning allows the LEDs to be visible to someone on the ground below the access point.

You must also ensure the access point is mounted with the hinged access cover facing out.

Omnidirectional antennas are vertically polarized and should be mounted vertically with the antennas 
facing down.

The optional pole mount kit contains a mounting bracket for wall mounting. You can use the mounting 
bracket as a template to mark the positions of the mounting holes for your installation. You then install 
the mounting plate, and attach the access point when you are ready. 

 lists the material that you 

will need to provide in addition to the pole mount kit.