Xerox 701P44973 Manual De Usuario

General Problems

10

If you think a problem is occurring with the machine, check the machine status again.

The machine contains precision measuring equipment and uses a high-voltage 
power supply, so never open or remove machine covers that are secured with screws 
unless specifically instructed in the User Guide because high voltage components 
can cause electric shock. Always follow the instructions in the User Guide when 
opening panels or covers that are secured with screws in order to retain your 
install/reinstall options. Do not attempt to alter the machine or change the parts 
because it may result in fire or smoke.

Power is not 
switched On.

Is the circuit breaker (main 
power switch) or the power 
switch of the machine off?

Turn on the circuit breaker and then the 
power switch.
Refer to "Power On / Off" (P.25).

Is the power cord plugged 
into the power outlet?

Turn off the circuit breaker and power 
switch, and firmly plug in the power cord. 
Then turn on the  circuit breaker (main 
power switch) and power switch.
Refer to "Power On / Off" (P.25).

Is the power cord 
disconnected from the 
machine?

Is power of the correct 
voltage being supplied?

Make sure that the power supply is 120 V 
(volts), 15 A (amperes) in the U.S., and 
220-240 V in Europe.
Refer to "Power Connection" (P.15).

Touch screen is 
dark.

Is the <Power Saver> 
button on?

The machine is in the Power Saver mode. 
Press the <Power Saver> button on the 
control panel to cancel the Power Saver 
mode.
Refer to "Power Saver Mode" (P.27).

Is [Backlight Off] set to [Off] 
in the System Settings?

Press any button on the Control Panel or 
touch the touch screen.
For information about backlight off settings, 
refer to "Auto Clear" (P.124).

Is the brightness dial set too 
low?

Use the brightness dial to adjust display 
brightness.
Refer to "Control Panel" (P.21).

A message is 
displayed.

Did a paper jam occur?

Refer to "Paper Jams" (P.176).

Did the original jam?

Refer to "Original Document Jams" (P.175).

Is the message "Please 
wait..." displayed?

If the message is displayed for more than 3 
minutes, contact your Xerox Customer 
Support Center.