Xerox 701P44973 Manual De Usuario

Problems during Printing

10

The following helps you solve problems encountered during printing.

Unable to print.

Is the circuit breaker or the 
power switch of the machine 
off?

Turn on the circuit breaker (main power 
switch) and the power switch.
Refer to "Power On / Off" (P.25).

Is the print mode [Offline]?

Press the <Machine Status> button, and 
confirm [Print mode] in the [Machine 
Status] screen. If [Print Mode] is [Offline], 
select [Online] in the [Print Mode] screen.

Is the network cable of the 
machine disconnected?

Connect the network cable of the machine.

Does any error occur on the 
machine?

Check the error message, and follow the 
instructions to solve the problem.

Is the network path of the IP 
address correctly set?

Set the network path of the IP address 
correctly.

Is an interrupt operation 
performing?

Cancel the interrupt operation.

Unable to print 
using the manual 
feed tray 
(Bypass).

Is the specified media size 
paper loaded correctly?

Load the correct size paper media in 
accordance with the message appears and 
print again.
Refer to "Using the Manual Feed Tray 
(Bypass)" (P.36).

Paper media is 
often jammed or 
wrinkled.

Is the correct type of paper 
media used?

Load a correct type of paper media.
Refer to "Media Type" (P.32).

Is the paper media loaded 
correctly?

Load the paper media correctly.
Refer to "Loading Media" (P.34).

Is the media tray set 
correctly?

Firmly push in the media tray until it stops 
to set it correctly.
Refer to "Loading Media" (P.34).

Is the paper media damp?

Replace with paper media from a new 
ream.
Refer to "Loading Media" (P.34).

Are the media loaded and 
media settings correct?

Correctly select the media size series and 
media type to match with the media 
loaded.
Refer to "Media Settings" (P.39).

Are there any torn pieces of 
paper still remaining inside 
the machine or is there a 
foreign object in the 
machine?

Open the door of the machine or slide out 
the media try to remove the torn paper or 
the foreign object.
Refer to "Paper Jams" (P.176), "Loading 
Media" (P.34).

The prints are 
too light.

Is the message for load 
toner displayed?

Load toner.
Refer to "Loading Toner" (P.154).

Is the toner density 
appropriate?

Adjust the toner density.
Refer to "Toner Density" (P.128).