abit AN7 Manual De Usuario
Hardware Setup
2-3
2-3. Install System Memory
This motherboard provides 3 184-pin DDR DIMM sites for memory expansion available from minimum
128MB to maximum 3GB.
128MB to maximum 3GB.
Table 2-1. Valid Memory Configurations
Bank
Memory Module
Total Memory
Bank 0, 1 (DIMM1)
128, 256, 512MB, 1GB
128MB ~ 1GB
Bank 2, 3 (DIMM2)
128, 256, 512MB, 1GB
128MB ~ 1GB
Bank 4, 5 (DIMM3)
128, 256, 512MB, 1GB
128MB ~ 1GB
Total System Memory for Un-buffered DDR 200/266/333 DIMM
128MB ~ 3GB
Total System Memory for Un-buffered DDR 400 DIMM
128MB ~ 2GB
NOTE: We suggest you to install DDR SDRAM modules from DIMM3 to DIMM1 sockets in order.
Power off the computer and unplug the AC power cord before installing or removing memory modules.
1. Locate the DIMM slot on the board.
2. Hold two edges of the DIMM module
carefully, keep away of touching its
connectors.
connectors.
3. Align the notch key on the module with the
rib on the slot.
4. Firmly press the module into the slots until
the ejector tabs at both sides of the slot
automatically snaps into the mounting notch.
Do not force the DIMM module in with extra
force as the DIMM module only fit in one direction.
automatically snaps into the mounting notch.
Do not force the DIMM module in with extra
force as the DIMM module only fit in one direction.
5. To remove the DIMM modules, push the two ejector tabs on the slot outward simultaneously, and
then pull out the DIMM module.
ATTENTION: Static electricity can damage the electronic components of the computer or optional
boards. Before starting these procedures, ensure that you are discharged of static electricity by touching a
grounded metal object briefly.
boards. Before starting these procedures, ensure that you are discharged of static electricity by touching a
grounded metal object briefly.
User’s Manual