IBM 2251 Manual De Usuario
If NO, continue to
002.
If YES, proceed to
003.
002
If the Power Management feature is enabled, do the following:
1.
1.
Start the Configuration/Setup Utility program (see “Setup Utility program” on
page 8)
page 8)
2.
Select Power Management from the Configuration/Setup Utility program
menu.
menu.
3.
Select APM.
4.
Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (
}) or
Right Arrow (Æ) to change the setting.
5.
Select Automatic Hardware Power Management.
6.
Set Automatic Hardware Power Management to Disabled.
7.
If the problem persists, continue to
003.
003
Run diagnostics. If necessary, refer to “Diagnostics” on page 10.
v If you receive an error, replace the part that diagnostics calls out or go to
v If you receive an error, replace the part that diagnostics calls out or go to
″Symptom-to-FRU Index″ on page 39.
v If the test stops and you cannot continue, replace the last device tested.
2
Hardware Maintenance Manual