Gigabyte 5225 Manual De Usuario

- 55 -

BIOS Setup

English

} Standard CM OS Features

} Advanced BIOS Features

} Advanced Chipset Features

} Integrated Peripherals

} Power M anagement Setup

} PnP/PCI Configurations

} PC Health Status

} Frequency/Voltage Control

Load Fail-Safe Defaults

Load Optimized Defaults

Set Supervisor Password

Set User Password

Save & Exit Setup

Exit Without Saving

ESC: Quit

higf: Select Item

F8: Dual BIOS / Q-Flash

F10: Save & Exit Setup

Change/Set/Disable Password

Set Supervisor/User Password

When you select this function, the following message will appear at the center of the screen to assist

you in creating a password.

Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the

password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.

To disable password, just press <Enter> when you are prompted to enter password. A message

"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.

The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access

all BIOS Setup program function. When enabled, the Supervisor password is required for entering the
BIOS Setup program and having full configuration fields, the User password is required to access only
basic items.

If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be

prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.

If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted

only when you try to enter Setup.

Figure 12: Password Setting

Enter Password:

7n400e_1001_b.p65

2003/7/17, 下午 02:37