Addonics Technologies R1R2ES Manual De Usuario

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

When configured as a set of individual drives and connected to a SATA or an 

eSATA host adapter, the Port Multiplier will only work with a Port Multiplier aware 

host. Identify your host controller and check with its hardware manufacturer if 

you are unsure. Addonics offers several Port Multiplier aware host adapters.

1. Use the provided key to unlock the front door if needed and open it.

2. Insert a drive into each bay as desired, SATA connectors first, label side up as 

shown, then press the drive firmly into place.

3. Connect the Host eSATA cable to a computer. If desired, connect an external 

eSATA drive to the Drive eSATA connector.

4. Make sure the AC input switch is set correctly, then connect the power cord to 

an AC outlet.

5. Set the AC power switch on the rear to ON, then press the power button 

behind the front door to turn on the unit.

To remove a drive, pull the Eject Lever until the drive disengages from the 

internal connector then pull the drive out.

The R1R2ES unit supports hot swapping (inserting or removing drives while the 

drives are running and connected to a computer). The eSATA controller on the 

computer must also support hot swapping - be sure to confirm this before 

attempting to insert or remove drives while the system is running. Also be sure to 

practice the appropriate safe 

removal procedure before 

proceeding. Failure to practice 

safe removal procedures will 

result in loss or corruption of data.