3com 100 PCI Manual De Usuario

Descargar
Página de 12
 
Installing the Driver and Software
 
7
 
9 Connect the appropriate network cable to the RJ-45 
port on the NIC, following the specifications in the 
table below.
 
The next step is to install the NIC driver and software.
 
Installing the Driver and Software
 
This section describes how to install the NIC driver and 
software on a PC running Windows 95 or Windows 98. 
For other operating systems, see the user guide.
 
Windows 95
 
To install the NIC driver and software under Windows 95, 
you need the Windows 95 installation files. These files 
may be on a CD or diskettes, or they may have been copied 
to your hard drive when Windows 95 was installed on 
your PC.
 
If you encounter problems during the installation, see 
the W95NDIS.TXT file located in the HELP directory on 
 
EtherDisk
 
 diskette 3 for troubleshooting tips.
 
Before installing the NIC driver and software:
 
 
Make sure that you have run the preinstallation 
program, as described earlier in this guide.
 
 
Make sure that the NIC is installed in the PC and 
that it is connected to the network.
To install the NIC driver and software on a PC running 
Windows 95:
 
1 Turn on the power to the PC.
 
Windows 95 detects the NIC. Depending on the version of 
Windows 95 that you have installed, the New Hardware 
Found dialog box appears or the Update Device Driver 
Wizard starts.
 
Network 
Environment
Cable Required
Maximum 
Cable Length
 
10 Mbps 
(10BASE-T)
Category 3, 4, or 5 
unshielded twisted-pair 
100 m (328 ft)
100 Mbps
(100BASE-TX)
Category 5 unshielded 
twisted-pair
100 m (328 ft)
 
Book  Page 7  Friday, March 19, 1999  11:21 AM