Siemens NCM S7 Manual De Usuario
Configuring Communication Connections
127
SIMATIC NET NCM S7 for Industrial Ethernet
Release 6/2003
Release 6/2003
C79000–G8976–C129–07
4.7
Configuring UDP Connection Properties
Introduction
When you create a connection in the New dialog, you specify the connection type
and, as far as possible, the connection partner.
and, as far as possible, the connection partner.
When necessary, you can adapt other connection partners that are set as default
when you create a new connection as described below.
when you create a new connection as described below.
Opening the Dialog
To call the dialog for special connection properties, follow the steps outlined below:
1. Select the required connection in the connection table.
2. Select the menu option Edit
"
Object Properties
Result The “Properties – UDP Connections“ dialog appears.
Tabs
The following tabs are available for UDP connections:
S
General
Displays parameters that identify the connection.
Displays parameters that identify the connection.
S
Addresses
Displays the local and remote address information.
Displays the local and remote address information.
S
Overview
Overview of all configured UDP connections of the selected S7 station with
corresponding parameters and the status of the connection.
Overview of all configured UDP connections of the selected S7 station with
corresponding parameters and the status of the connection.
S
Status Information
This tab displays the current status information for the connection (valid at the
time the dialog is opened). This information corresponds to that displayed by
NCM diagnostics.
This tab displays the current status information for the connection (valid at the
time the dialog is opened). This information corresponds to that displayed by
NCM diagnostics.