Siemens NCM S7 Manual De Usuario

210

SIMATIC NET NCM S7 for Industrial Ethernet

Release 6/2003

C79000–G8976–C129–07

When running diagnostic functions, the following menu commands have general
significance. Depending on the context, other functions may be available; for more
detailed information refer to the online help for NCM Diagnostics.

Table 7-1

Meaning of the Menu Commands

Diagnostics

"

Open Online Connection...

Diagnostics

"

Close Online Connection...

With this menu command, you can establish a connection to a different CP
you want to check without having to quit and restart the diagnostic tool. The
current diagnostic connection is closed.

If you want to use more than one diagnostic connection at the same time,
you can start NCM S7 diagnostics more than once.

Operating Mode

"

You can control the CP as follows:

Stop a module

Stops the CP.

Start a module

Starts the CP if the RUN/STOP switch is set to RUN.

Reset module memory

With certain CP types, for example the CP 443-1, you can reset the CP
memory. This function must be confirmed before it is executed.

Following this memory reset, the CP retains the preset MAC address and
the retentive parameters. The CP is therefore immediately ready for
downloads.

The retentive parameters include:

S

IP address and IP parameters

S

A newly set MAC address

S

LAN settings

Resetting to factory
settings

With some modules, it is possible to reset to the factory settings.

When you reset to the factory settings, the retentive parameters are also
deleted. After this, the module retains only the factory-set MAC address (as
shipped).

View 

"

 Update

Each time you activate this menu command, the displayed diagnostic and
status information is updated once.

View 

"

Update Cyclically

Using this menu command, you activate and deactivate the automatic
(cyclic off) updating of the displayed diagnostic and status information.

You can set the interval between update points with the menu command
Options 

"

 Customize.