Manualsbrain.com
  1. Manuales
  2. Marcas
  3. PioneerPOS
  4. G24-LC
  5. Manual De Usuario

PioneerPOS G24-LC Manual De Usuario

Descargar
Página de 444
Chapter 3:  AT Commands Reference
 April 15, 2008
G24-L AT Commands Reference Manual
3-111
If after aborting AT+CMGS command execution and before result of operation was 
reported by G24-L, a second AT+CMGS command is executed, then the result of the 
second AT+CMGS operation only will be reported by G24-L.
+MCSAT, Motorola Control SMS Alert Tone
This command enables/disables/exercises the SMS alert tone for an arriving SMS. It does not 
apply on Cell Broadcast SMS.
The following table shows the +MCSAT parameters.
Command 
Type
Syntax
Response/Action
Remarks
Set
+MCSAT=<mode> 
[,<dcs_mask>[,....]]
OK
or:
+CME ERROR: <err>
The Set command is used to:
•
Suppress (mute) the voice notification 
(alert tone) of a specific incoming SMS, 
identified by the received <dcs_mask>s 
property
•
Enable voice notification (alert tone) of 
all incoming SMS events
•
Activate the current alert tone for an 
incoming SMS event
Read
+MCSAT?
+MCSAT: 
<mode>[,<dcs_mask>[,
....]]
OK
or:
+CME ERROR: <err>
The Read command returns the current 
<mode> and current <dcs_mask>s.
Test
+MCSAT=?
+MCSAT: (list of 
supported <mode>s)
OK
or:
+CME ERROR: <err>
The Test command returns the possible 
<mode> values.
Table 3-71: +MCSAT Parameters
<Parameter>
Description
<mode>
0
Suppress alert tone
1
Enable alert tone
2
Play alert tone
The default value at power-up is 1.
<dcs_mask>
SMS data coding-scheme mask. The format is an 8-bit information parameter. Each 
bit contains 0, 1, or X (ASCII character):
0 
Condition is met if the arriving SMS includes dcs with 0 in this position
1 
Condition is met if the arriving SMS includes dcs with 1 in this position
X or x This bit is ignored from the dcs of the arriving SMS