Cisco Systems Cisco IOS XR Manual De Usuario
3-8
Cisco IOS XR Getting Started Guide
OL-10957-02
Chapter 3 Bringing Up the Cisco IOS XR Software on a Multishelf System
Configuring the External Cisco Catalyst 6509 Switches
•
To display the configured chassis serial numbers in administration EXEC mode, see Cisco IOS XR
System Management Configuration Guide, Release 3.4.
System Management Configuration Guide, Release 3.4.
•
To display the chassis serial numbers in ROM Monitor, see Cisco IOS XR ROM Monitor Guide.
See the
up a new router and configure the rack numbers.
Configuring the External Cisco Catalyst 6509 Switches
The control Ethernet network is formed by interconnecting each RP and shelf controller Gigabit Ethernet
(SCGE) card in the system through two external Catalyst switches. (The SCGE card is the control card
in an FCC.) The Catalyst switches are also directly connected using one or more Gigabit Ethernet links
(see
(SCGE) card in the system through two external Catalyst switches. (The SCGE card is the control card
in an FCC.) The Catalyst switches are also directly connected using one or more Gigabit Ethernet links
(see
These Catalyst switches must also be configured for operation with the Cisco CRS-1 multishelf router.
This section includes instructions to configure and verify the Catalyst switches using the Cisco IOS
software. For instructions to install and cable the Catalyst switches, see CRS-1 Multishelf System
Interconnection and Cabling Guide.
This section includes instructions to configure and verify the Catalyst switches using the Cisco IOS
software. For instructions to install and cable the Catalyst switches, see CRS-1 Multishelf System
Interconnection and Cabling Guide.
This section includes the following topics:
•
•
•
•
•
•