Cisco Systems BC-109 Manual De Usuario
Configuring Source-Route Bridging BC-109
Configuring Source-Route Bridging
This chapter describes source-route bridging (SRB) configuration tasks. For a discussion of remote
source-route bridging (RSRB) configuration tasks, refer to the “Configuring Remote Source-Route
Bridging” chapter in this publication.
source-route bridging (RSRB) configuration tasks, refer to the “Configuring Remote Source-Route
Bridging” chapter in this publication.
For a complete description of the SRB commands mentioned in this chapter, refer to the
“Source-Route Bridging Commands” chapter in the Bridging and IBM Networking Command
Reference. To locate documentation of other commands that appear in this chapter, use the command
reference master index or search online.
“Source-Route Bridging Commands” chapter in the Bridging and IBM Networking Command
Reference. To locate documentation of other commands that appear in this chapter, use the command
reference master index or search online.
SRB Configuration Task List
Perform the tasks in the following sections to configure SRB:
•
•
•
•
•
•
•
•
•
See the end of this chapter for “SRB Configuration Examples.”
Warning
The Cisco IOS software issues a warning if a duplicate bridge definition exists in a router. You
must remove an old bridge definition before adding a new bridge definition to a router configuration.