Cisco Systems 1000 Series Manual De Usuario

This section describes how to connect to the console port on the router and use the console interface to 
access the CLI. 

The console port on a Cisco ASR 1000 Series Router is an EIA/TIA-232 asynchronous, serial connection 
with no flow control and an RJ-45 connector. The console port is located on the front panel of each Route 
Processor (RP).

To connect to the console port, complete the following steps:

Configure your terminal emulation software with the following settings:

9600 bits per second (bps) 

8 data bits

No parity

1 stop bit

No flow control

Connect to the port using the RJ-45-to-RJ-45 cable and RJ-45-to-DB-25 DTE adapter or using the 
RJ-45-to-DB-9 DTE adapter (labeled “Terminal”). 

Every RP on a Cisco ASR 1000 Series Router has a console interface. Notably, a standby RP can be 
accessed using the console port in addition to the active RP in a dual RP configuration.

To access the CLI using the console interface, complete the following steps:

After you attach the terminal hardware to the console port on the router and you configure your terminal 
emulation software with the proper settings, the following prompt appears:

Press RETURN to get started.

Press Return to enter user EXEC mode. The following prompt appears:

Router>

From user EXEC mode, enter the enable command as shown in the following example:

Router> enable

At the password prompt, enter your system password. If an enable password has not been set on your 
system, this step may be skipped.
The following example shows entry of the password enablepass:

Password: enablepass

When your enable password is accepted, the privileged EXEC mode prompt appears:

Router#