Cisco Systems 1000 Series Manual De Usuario
5-171
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
Using ISSU to Upgrade the Subpackages in a Dual Route Processor Configuration with MDR
Step 10
issu checkversion rp standby-RP file
standy-file-system:asr1000rp*version*.pkg mdr
{force}
standy-file-system:asr1000rp*version*.pkg mdr
{force}
Example:
Router#issu checkversion rp 1 file
stby-bootflash:asr1000rp2-*03.13.00.S.154-3.S-e
xt*pkg mdr
Checks the ISSU MDR software packaging compatibility
on the standby Route Processor (RP).
on the standby Route Processor (RP).
Step 11
issu loadversion rp
standby-RP
file
target-standbyRP-URL-for-sub-packages
:asr1000rp*
version
*.pkg
force
Example:
Router# issu loadversion rp 1 file
stby-bootflash:asr1000rp2-*03.13.00.S.154-3.S-e
xt*pkg force
Upgrade the RP subpackages on the standby RP, where the
“rp*” wildcard is specified to capture all of the RP
subpackages for the desired upgrade release.
“rp*” wildcard is specified to capture all of the RP
subpackages for the desired upgrade release.
Step 12
hw-module slot
standby-RP
reload
Example:
Router# hw-module slot R1 reload
Reload the standby RP.
Step 13
issu loadversion rp
active-RP
file
URL-to-active-file-system
:asr1000rp2-{sipbase,sip
spa}*
version
*.pkg slot
SIP-slot-number mdr
{force}
issu commitversion
Example:
Router# issu loadversion rp 0 file
bootflash:asr1000rp2-{sipbase,sipspa}*03.13.00*
pkg mdr
Router# issu commitversion
Upgrade the SIP and SPA subpackages for each SIP on the
router using MDR.
router using MDR.
Note
This step must be completed one SIP at a time, and
repeated for each SIP installed on the router before
performing the next step.
repeated for each SIP installed on the router before
performing the next step.
Tip
You can use the show ip interface brief command
to identify which slots contain SIPs and SPAs. The
interfaces with three numbers (in the form
SIP-number/SPA-number/interface-number)
identify the SIP and SPA locations in the router.
to identify which slots contain SIPs and SPAs. The
interfaces with three numbers (in the form
SIP-number/SPA-number/interface-number)
identify the SIP and SPA locations in the router.
Note
The pattern options used in this CLI (sipbase and
sipspa) were introduced in Cisco IOS XE Release
2.1.2 and are not available in previous Cisco IOS
XE Releases.
See the
sipspa) were introduced in Cisco IOS XE Release
2.1.2 and are not available in previous Cisco IOS
XE Releases.
See the
for pre-Cisco
IOS XE Release 2.1.2 ISSU upgrade procedures.
Command or Action
Purpose