Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Cisco Systems
  4. 1000 Series
  5. Manual De Usuario

Cisco Systems 1000 Series Manual De Usuario

Descargar
Página de 702
 
10-4
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-15
Chapter 10      Using the Management Ethernet Interface
  Common Ethernet Management Tasks
Viewing the VRF Configuration
The VRF configuration for the Management Ethernet interface is viewable using the show 
running-config vrf command.
This example shows the default VRF configuration:
Router# show running-config vrf
Building configuration...
Current configuration : 351 bytes
vrf definition Mgmt-intf
 !
 address-family ipv4
 exit-address-family
 !
 address-family ipv6
 exit-address-family
!
(some output removed for brevity)
Viewing Detailed VRF Information for the Management Ethernet VRF
To see detailed information about the Management Ethernet VRF, enter the show vrf detail Mgmt-intf 
command:
Router# show vrf detail Mgmt-intf
VRF Mgmt-intf (VRF Id = 4085); default RD <not set>; default VPNID <not set>
  Interfaces:
    Gi0                     
Address family ipv4 (Table ID = 4085 (0xFF5)):
  No Export VPN route-target communities
  No Import VPN route-target communities
  No import route-map
  No export route-map
  VRF label distribution protocol: not configured
  VRF label allocation mode: per-prefix
Address family ipv6 (Table ID = 503316481 (0x1E000001)):
  No Export VPN route-target communities
  No Import VPN route-target communities
  No import route-map
  No export route-map
  VRF label distribution protocol: not configured
  VRF label allocation mode: per-prefix
Setting a Default Route in the Management Ethernet Interface VRF
To set a default route in the Management Ethernet Interface VRF, enter the following command
ip route vrf Mgmt-intf 0.0.0.0 0.0.0.0 next-hop-IP-address
Setting the Management Ethernet IP Address
The IP address of the Management Ethernet port is set like the IP address on any other interface.