Cisco Systems 1000 Series Manual De Usuario
18-14
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 18 LSM-MLDP-based MVPN Support
Router(config-vrf)# route-target export 10:4
Router(config-vrf)# mdt default mpls MLDP 2.2.2.2
Router(config-vrf)# end
Router(config)# interface loopback 3
Router(config-if)# ip vrf forwarding blue
Router(config-if)# ip address 3.3.3.3 255.255.255.255 Remove
Router(config-if)# ip mroute vrf red 40.0.0.0 255.255.255.0 1.1.1.1
Router(config-vrf)# end
Configuring MLDP MVPN for Extranet Services using RSC
Complete these steps to configuring MLDP MVPN for extranet services using RSC:
•
Configuring the source mVRF on the receiver PE router.
•
Configuring RPF for MLDP based MVPN extranet support using static multicast routes on the
receiver PE.
receiver PE.
Note
This configuration is based on illustration
. Configure multicast routes on PE2 and PE3
routers.
SUMMARY STEPS
Configuration on Source PE:
1.
enable
2.
configure terminal
3.
vrf definition vrf-name
4.
rd route-distinguisher
5.
vpn id vpn_id
6.
route-target import route-target-ext-community
7.
route-target import route-target-ext-community
8.
mdt default mpls MLDP root-node
9.
end
Configuration on Receiver PE (Configure these steps for both red and blue VRFs)
1.
enable
2.
configure terminal
3.
vrf definition vrf-name
4.
rd route-distinguisher
5.
vpn id vpn_id
6.
route-target import route-target-ext-community
7.
route-target import route-target-ext-community
8.
mdt default mpls MLDP root-node
9.
ip mroute [vrf recevier-vrf-name] source-address mask fallback-lookup {global | vrf
source-vrf-name} [distance]
source-vrf-name} [distance]
10.
end