Cisco Systems 1000 Series Manual De Usuario

18-65

Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide

OL-16506-17

Chapter 18 LSM-MLDP-based MVPN Support

MVPN MLDP over GRE

32.

end

DETAILED STEPS

Command

Purpose

Step 1

enable

Example:

Router> enable

Enables the privileged EXEC mode. Enter your password
when prompted.

Step 2

configure

terminal

Example:

Router# configure terminal

Enters the global configuration mode.

Step 3

mpls MLDP

Example:

Router(config)# mpls MLDP

Enables MPLS MLDP support.

Note

The mpls MLDP command is configured by
default. To disable MPLS MLDP, use the no mpls
MLDP command.

Step 4

vrf definition

vrf-name

Example:

Router(config)# vrf definition blue

Defines the VPN routing instance by assigning a VRF
name, and enters the VRF configuration mode.

vrf-name—Name assigned to a VRF.

Step 5

route-distinguisher

Example:

Router(config-vrf)# rd 200:2

Creates routing and forwarding tables.

route-distinguisher— Specifies the 8-byte value to create
a VPN prefix.

You can enter a route-distinguisher value in either of
these formats:

•

16-bit autonomous system number: Your 16-bit
number Example, 200:2.

•

32-bit IP address: Your 32-bit number Example,
192.168.122.15:1.

Step 6

vpn id

vpn-id

Example:

Router(config-vrf)# vpn id 200:2

Sets or updates a VPN identifier on a VRF.

Step 7

address-family ipv4

Example:

Router(config-vrf)# address-family ipv4

Enters the address family configuration mode using
standard IP Version 4 (IPv4) address prefixes.