Cisco Systems 2500 SERIES Manual De Usuario

The PTZ (RS-485) window allows you to enable pan, tilt, zoom (PTZ) functions for the IP camera. These 
functions require that the IP camera be installed with a motorized zoom/focus lens in a pan/tilt mount 
that supports the Pelco D protocol.

This window also provides options for configuring a patrol sequence, or sequence, for the IP camera. A 
sequence consists of up to 20 steps, each of which causes the camera to move to a designated position 
and remain in the position for 30 seconds.

To display the PTZ (RS-485) window, access the configuration windows as described in the 

, click Applications, then click PTZ (RS-485).

If you change any options in the PTZ (RS-485) window, you must click Save to save the changes. To 
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the 
window. You may need to scroll down to see them.

 describes the options in the PTZ (RS-485) window.

Enable External PTZ

Check this check box to enable configuration of the PTZ settings.

Baud Rate

Choose the Baud rate value that is configured on the device that controls the 
PTZ functions of the IP camera.

Data Bits

Choose the data bits value that is configured on the device that controls the 
PTZ functions of the IP camera.

Parity

Choose the parity value that is configured on the device that controls the PTZ 
functions of the IP camera.

Stop Bits

Choose the stop bits value that is configured on the device that controls the 
PTZ functions of the IP camera.

Address

Enter the logical address of the external PTZ device.

To determine this address, refer to the documentation for the device.

The Preset Position option appears if you check the Enable External PTZ check box.

Set Preset Position

Click the Set Preset Position button to define a preset position of the IP 
camera.

When you click this button, the Set Pan/Tilt window appears. For detailed 
information about this window, see the 

.