GarrettCom 6K32F Manual De Usuario

Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (05/08) 

Each port has an Activity (ACT) LED indicating packets being received, a 

Link (LK) LED that indicates proper connectivity with the remote device when lit, a 

FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off), and a 

and 

“10/100” LED indicating 100Mb when lit (or 10 Mbps when off). 

Important Note:  The 10/100 RJ-45 ports are supported with Auto-negotiation 
Aut

J-

o-crossover (MDIX), which allow the RJ-45 ports to automatically Link with any R

45 device and eliminate the use of cross-over cable.  

The RJ-45 pins normally (TP crossover switch) are per the standard for hubs-to-
users twisted pair wiring: 1 = receive+, 2 = receive-, 3 = transmit+, 6 = transmit-, 
other pins not used.  When the TP crossover push-button is UP, the pins of the RJ-
45 port are per the standard for up-links using twisted pair wiring, i.e., the transmit 

 

and the receive pairs are exchanged: 1 = transmit+, 2 = transmit-, 3 = receive+, 6 =
receive-, other pins not used.  

for Power Substations:   In support of the IEEE 1613 Class 2 standard, GCI 

advises that, for substation applications, the RJ-45 ports are intended for 
connectivity to other communication equipment such as routers or 
telecommunication multiplexers installed in close proximity (i.e., less than 2 
meters or 6.5ft) to the 6K32. It is not recommended to use these ports in 
substation applications to interface to field devices across distances which 
could produce high (greater than 2500V ) levels of ground potential rise (GPR) 
during line-to-ground fault conditions. The 6K32 passes the 1613specifications 
for zero packet loss with fiber ports & with RJ45 ports used as indicated here. 

 

g power on each port to power up the PD devices, per the 

dard. The Power Pass-through PoE modules are totally dependent 

e 

d 

lso available with mix –n-match with fiber modules. Please check the ordering 

PoE (Power Pass-through), model P6KP8V-RJ45 (MDIX), 10/100Mb 8-
port 
The PoE RJ-45 ports act similar to regular RJ-45 ports, except they have the 

capability of providin

IEEE802.3af PoE stan

upon the powerful  -

48VDC input power 

supply to support mor

RJ-45 (10/100) ports. 

Each port requires at 

least 15watts to power 

up the PoE PD devices. 

In this Fig. the top 8-

RJ45 ports are enhance

with POE option.  The 8-

RJ45 POE modules are 

a

 

55 

.

.