ATTO Technology 2390C/R/D Guía Del Usuario
16
3
Enter the Administrator (
Admin) password
where indicated.
4
Enter appropriate information into the
New
Admin Password, Confirm New Admin
Password or New Read Only Password and
Confirm New Read Only Password text
boxes.
Password or New Read Only Password and
Confirm New Read Only Password text
boxes.
5
Click
Submit.
6
If you have completed all changes for this
session, go to the
session, go to the
Restart page and restart the
Fibre Bridge.
Enhance performance
SpeedWrite is a method to improve the
performance of WRITE commands to SCSI tape
devices attached to the FibreBridge.
SpeedWrite is a method to improve the
performance of WRITE commands to SCSI tape
devices attached to the FibreBridge.
Using the CLI command SpeedWrite, you can
specify the SCSI bus, target and LUN of a
specify the SCSI bus, target and LUN of a
mapped device or specify [all] to set or get the
state of all currently mapped SCSI devices.
state of all currently mapped SCSI devices.
SpeedWriteDefault specifies the state of
SpeedWrite for any SCSI devices mapped
manually or via an AutoMap operation. If
enabled, any new SCSI device uses SpeedWrite
performance enhancement by default.
SpeedWrite for any SCSI devices mapped
manually or via an AutoMap operation. If
enabled, any new SCSI device uses SpeedWrite
performance enhancement by default.
1
Follow the
.
2
From the left hand menu, click on
Storage
Management.
3
Select the parameters you wish to change.
4
Click
Submit.
5
If you have completed all changes for this
session, go to the
session, go to the
Restart page and restart the
FibreBridge.