Cisco Systems 5709 Manual De Usuario

NetXtreme II

User Guide

January 2010

Bro a d c o m C o rp o r a ti o n

Page 112

Installing the NDIS2 Driver Software for Use on MS-DOS Platforms

Document

ENGSRVT52-CDUM100-R

lastdrive=z

NSTALLING

THE

DOS NDIS2 D

RIVER

OFTWARE

THE

ARD

ISK

To install the DOS NDIS2 Driver Software on the hard disk

1. Verify that the system has Microsoft LAN Manager 2.2 installed, with a protocol such as NetBEUI configured.

2. Create a folder on your hard disk to store the NDIS 2.01 driver.

Example: C:\LANMAN

3. Copy the BXND20X.dos file to this folder.

Edit the Config.sys file by adding the following lines:

DEVICE = C:\LANMAN\PROTMAN.DOS

DEVICE = C:\LANMAN\BXND20X.DOS

DEVICE = C:\LANMAN\NETBEUI.DOS

4. Edit the Autoexec.bat file by adding the following lines:

C:\ LANMAN\NETBIND.EXE

C:\LANMAN\NET START WORKSTATION

C:\LANMAN\NET USE drive letter: \\server name\resource name

5. Edit the Protocol.ini file (located in C:\LANMAN) to configure the driver to bind with NetBEUI or any other protocols.

Example:

[PROTOCOL MANAGER]

DriverName = PROTMAN$

[NETBEUI_XIF]

DriverName = netbeui$

BINDINGS = BXND20X

[BXND20X]

DriverName = "BXND20X$"

6. Restart the computer to complete the installation.

NOTE: The driver loads during system configuration and displays the Broadcom banner, controller name, MAC
address, IRQ number, detected line speed, and the controller BusNum and DevNum. If the driver fails to load, an
initialization fail message is displayed.