Cisco Systems 566 Manual De Usuario

Touch the static-protective package containing the adapter to any unpainted metal 
surface on the Content Engine and then remove the adapter from the 
static-protective package. Avoid touching the components and gold-plated edge 
connectors on the adapter.

Place the adapter, component-side up, on a flat, static-protective surface and set 
any jumpers or switches as described by the adapter manufacturer, if necessary.

When you install an adapter in the Content Engine, be sure that it is completely 
and correctly seated in the PCI expansion slot before you power up the 
Content Engine. Incomplete insertion might cause damage to the system board or 
the adapter.

To install the adapter, carefully grasp the adapter by its top edge or upper corners, 
align it with the PCI-X slot 1 connector (labeled 2 in 

), and then press 

the adapter firmly into the expansion slot.

Reinstall the riser card. Make sure that the riser card is fully seated in the riser 
card connector (labeled 5 in 

) on the system board.

Tighten the captive screw for expansion slot 1. 

Connect the required cables to the adapter.

If you have other hardware options to install, do so now; otherwise, go to the 

Fibre Channel is a high-speed data transport technology used for mass storage and 
networking. Fibre Channel technology is outlined in the SCSI-3 Fibre Channel 
Protocol (SCSI-FCP). 

The Fibre Channel adapter uses a multimode shortwave optical interface for 
distances up to 1640 feet (500 meters). It is a 2-gigabit (Gb) Fibre Channel device 
that supports data transfer rates up to 200 megabytes per second (MBps) half 
duplex and 400 MBps full duplex on optical interfaces.