Cisco Systems 511 Manual De Usuario

This section describes how to install a hard disk drive in the Content Engine. The 
CE-511 requires a Serial Advanced Technology Attachment (SATA) hard disk 
drive. CE-566 supports two 1-inch (2.54-cm) slim 3.5-inch (8.89-cm) LVD hard 
disk drives. The CE-566 requires a SCSI hard disk drive. 

To install a simple-swap SATA hard disk drive in a bay, complete the following 
steps.

All hard disk drives being used in the Content Engine should have the same 
throughput speed rating. Mixing hard disk drives with different speed ratings will 
cause all hard disk drives to operate at the lower throughput speed.

If your Content Engine has only one hard disk drive, install it in the left drive bay.

To maintain proper system cooling, do not operate the Content Engine for more 
than 10 minutes without either a hard disk drive or a filler panel installed in 
each bay.

Inspect the new drive for any signs of damage.

Review the information in the 

, and the 

Power down the Content Engine and peripheral devices, and disconnect the power 
cord and all external cables.

Press the release tabs on the bezel and pull the bezel away from the 
Content Engine. (See 

.)