Casio MA1003-B Manual De Usuario

IP Setup

IP Address

Specifies the projector IP address.
Initial Default: 192.168.100.10

Subnet Mask

Specifies a subnet mask value, which specifies the IP address range of the subnet 
to which the projector belongs.
Initial Default: 255.255.255.0

Default Gateway

Specifies the IP address of the device used as a gateway for access from a 
computer outside of the network to which the projector belongs.
Initial Default: 192.168.100.10

DHCP Setup

Auto/Disable

Specifies whether an IP address should be assigned automatically to a computer 
connected to the projector via wireless LAN. “Auto” causes an IP address to be 
assigned automatically, while “Disable” turns off auto assignment.
Initial Default: Auto

Starting IP Address

Specifies the start point of the range of IP addresses that are assigned 
automatically to computers. This setting is available only while “Auto” is selected 
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.11

Ending IP Address

Specifies the end point of the range of IP addresses that are assigned 
automatically to computers. This setting is available only while “Auto” is selected 
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.254

Wireless Setup

SSID

Wireless network ID name. This is normally referred to as the SSID, ESS-ID, or 
network name. Up to 24 single-byte alphanumeric characters can be entered.
Initial Default: casiolpj_default1 (casiolpj_default2 and casiolpj_default3 also are 
built into the projector.)

SSID Broadcast

Specifies whether SSID information broadcasting is enabled or disabled.
Initial Default: Enable

Channel

Specifies the channel used for wireless LAN communication. Selecting “Auto” 
causes auto selection of a channel that is appropriate for the current 
communication environment. To specify a channel number, select channel number 
1 through 11 from the list that appears when you click the [

] button to the right of 

the channel number.
Initial Default: Auto

Security

Specifies the security protocol. For more information, see “To configure security 
settings” (page 21).
Initial Default: WPA-PSK AES

Passphrase/WEP 
Key

Specifies the passphrase or WEP key in accordance with the security protocol 
selected with “Security” above. For more information, see “To configure security 
settings” (page 21).

IEEE 802.11n

Specifies whether wireless LAN standard IEEE 802.11n is enabled.
Initial Default: Enable

Channel Width

Specifies either “20MHz” or “Auto” for the IEEE 802.11n channel width.
Initial Default: 20MHz

Show User Name Display

Specifies whether the computer’s user name should appear on the projection 
screen when projection starts from a computer connected to the projector via 
wireless LAN.
Initial Default: On (User name displayed.)