Crestron electronic CP-X3014WN/ Manual De Usuario
62
7.4 Command Control via the Network
You can configure and control the projector via the network using RS-232C
commands.
commands.
Communication Port
The following two ports are assigned for the command control.
Command Control Settings (
22)
4) Click the [Enable] check box to open Network Control Port1 (Port: 23) to use
TCP #23. Click the [Enable] check box for the [Authentication] setting when
authentication is required, otherwise clear the check box.
authentication is required, otherwise clear the check box.
5) Click the [Enable] check box to open Network Control Port2 (Port: 9715) to
use TCP #9715. Click the [Enable] check box for the [Authentication] setting
when authentication is required, otherwise clear the check box.
when authentication is required, otherwise clear the check box.
6) Click the [Apply] button to save the settings.
Configure the following items from a web browser when command control is used.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter “http://192.168.1.10/” into the address bar of the web browser, and
1) Enter “http://192.168.1.10/” into the address bar of the web browser, and
select Projector Web Control from the selection window.
2) Enter your user name and password, and then click the [OK].
3) Click the [Port Settings] on the main menu.
3) Click the [Port Settings] on the main menu.
7. Other Functions
TCP #23 (Network Control Port1 (Port: 23))
TCP #9715 (Network Control Port2 (Port: 9715))
TCP #9715 (Network Control Port2 (Port: 9715))
• Command control is available only via the specified port above.
NOTE