Lexmark 350d Manual De Usuario

The manual feeder is located at the front of the printer and can only feed one sheet of print media at a time. For information 
on acceptable print media to use in the manual feeder, see What types of print media can be loaded? on page10.

To load the manual feeder:

Place a sheet of the selected print media, print side 
facing up, at the center of the manual feeder, but only to 
the point where its leading edge can contact the paper 
guides. Otherwise, the printer will engage the print 
media too soon and likely skew the print job.

Adjust the guides to the print media width.

Hold both sides of the print media close to the manual 
feeder, and push it into the printer until it automatically 
engages.

There is a brief pause between the time the printer 
engages the print media and when it feeds into the 
printer.

Note: Do not force the print media into the 

feeder. Forcing the media causes jams.

Insert envelopes with the flap side down and with the 
stamp area as shown.

Hold transparencies by the edges, and avoid touching the print side. Oil from your fingers can affect print quality.

For simplex printing, load letterhead faceup, with the top of the sheet entering first. For duplex printing, load 
letterhead facedown, with the top of the sheet entering first.

Set the Paper Size and Paper Type for the manual feeder to the correct value for the print media you loaded.

On the control panel, press 

 for 

.

Press 

 until 

appears.

Press  until 

appears, then press 

.

Press 

 until 

appears, and then press 

.

Press 

 until the media size you loaded appears, and then press 

.

Press  

to return to the 

 state.