Kodak 8650 Manual De Usuario
Setting up the printer
October 1997
2-23
Checking and changing printer settings
Before you make a test print—the last step in setting up the printer—
check that the printer settings are correct for the media you just loaded
and for the mode in which you are going to operate the printer.
check that the printer settings are correct for the media you just loaded
and for the mode in which you are going to operate the printer.
This section describes only how to check and set the mode and media
options. For complete information about printer settings, see Chapter 3
in this guide.
options. For complete information about printer settings, see Chapter 3
in this guide.
You use the buttons on the printer’s display panel (shown below) to look
at and change the printer settings.
at and change the printer settings.
Changing the operating mode
If you have the PostScript version of the printer, the printer has two
operating modes: PostScript and raster. The PostScript mode is the
factory default.
operating modes: PostScript and raster. The PostScript mode is the
factory default.
To change the mode to raster:
1. Press Setup/Select when READY appears in the display panel.
2. Press Print to scroll down (or Cancel to scroll up) through the
settings until SETUP:MODE appears.
3. Press Setup/Select to access the MODE options.
Power
Error
Cancel
Print
Setup/Select
scroll