Axis Communications 540+ Manual De Usuario

AXIS 540+/AXIS 560

103

The test button is located on the front right hand side of the AXIS 540+/AXIS 
560 and is used for:

•

Printing a test page to check the connection to the printer.

•

Printing a parameter list to see the print server’s current settings.

•

Performing a Factory Default of the print server.

If you want to change any of the parameters, use one of the methods described 
in Management and Configuration, on page 79.

Press the test button 

once to print a test page. The test page contains basic 

information about the AXIS 540+/AXIS 560. It is recommended that you print a 
test page every time you connect the print server to a printer.

Press the test button 

twice to print a parameter list showing the current AXIS 

540+/AXIS 560 settings. This list provides comprehensive details of all the 
parameters and their current status. Refer to Section 17  The Parameter List, on 

1. Remove the external power supply to switch off the print server.

2. Press and hold down the test button, while you reconnect the external 

power supply. 

3. Continue to hold down the test button until the network indicator remains 

constantly lit. This should take about 20 seconds.

4. Restart the print server by disconnecting and reconnecting the external 

power supply

.

For print servers with firmware version 6.43 and higher, a Factory Default will 
reset all AXIS 540+/AXIS 560 parameters and settings to their default values, 
except:
•Installed certificate
•Private key