Gateway 9210 Manual De Usuario

www.gateway.com

If you have problems after installing a new CMOS battery, try each of the following items, 
closing the case and restarting the server after each try:

■

Restart your server, then open the BIOS Setup utility by pressing and holding F2 while 
your server restarts. Correct any discrepancies.

■

Remove the side panel by following the instructions in 

, then make sure that all cables inside the case are attached securely. Also, make 

sure that the colored cable edges are aligned correctly and that the connectors do not 
miss any pins.

■

If you have the correct test equipment, make sure that the new battery has power. 
Although unlikely, your new battery may be defective.

Whenever a recoverable error occurs during the power-on self-test (POST), the BIOS 
displays an error message that describes the problem. The BIOS also sounds a beep code 
for errors when video is not available for text messages.

A PCI expansion card (for example, a RAID controller) can also issue audible errors by itself, 
usually consisting of one long tone followed by a series of short tones. For more 
information on the beep codes issued, check the documentation for that device.

To avoid bodily injury, do not attempt to troubleshoot your 
server problem if:

■

The power cord or plug is damaged

■

Liquid has been spilled into your server

■

Your server was dropped

■

The case was damaged

Instead, unplug your server and contact Gateway 
Technical Support or a qualified computer technician.